Gamechanger Assembly Instructions
Open the box. You will see two pieces of cardboard, one wide and one narrow.
Open the wide cardboard box first. Inside you will find the base, the seat, and at the very bottom of the box, the gas spring.
Behind the narrow piece of cardboard is the backrest. The plastic sleeve* is attached to it. It is important to remove the plastic sleeve before connecting the seat and gas spring.
*The S/M model is supplied without a plastic sleeve.
Place the base cross and insert the gas spring without force, then slip the plastic sleeve over the gas spring.
Place the seat cushion onto the gas spring. Make sure that the hole in front of the red sticker is used.
Place the fully assembled seat, with the base upside down, on the corner of the box.
Remove the cardboard from the metal bracket and unscrew the 4 screws from the metal bracket.
Attach the backrest to the mechanism using the screws and the included Allen key. Finally, replace the black plastic cap.
COMPLETE!
GAMECHANGER wishes you lots of fun sitting
service
